Part number for Syncro transmission mounts
This is something I noticed recently as I get ready to replace some of mine.
ETKA, North American and Euro, all years, all models of
syncro:
183 199 381 A
But...ALL the ones I've seen (my own since new '91 14", a euro
14" and 16" single cab) all show on the part:
183 199 383 A
I had planned on clearing this up with my local dealer in the next few weeks.
Let us know if you get to the bottom of it.
Serge
For the 85-92 Syncro there
are a whole horde of rear mudflaps listed.
Small ones, which I imagine are the ones you want:
251 821 811B Left
251 821 812B Right
There are some large ones with VW insignia too:
251 821 811A and 812A
Stock Boge Shocks. VW Part Numbers for the three different sets of VW Boge shocks available for the syncro are:
Front: 251 413 031 C standard 14" syncro shock (USA)
251 413 031 M 14'' HD shock "Schlechtwegepaket"
251 413 031 N 16'' syncro shock
.
Rear: 251 513 031 D standard 14" syncro shock (USA)
251 513 031 M 14'' HD shock "Schlechtwegepaket"
251 513 031 N 16'' syncro shock
GOOD NEWS WHEN REPLACING FRONT WHEEL BEARINGS.
VOLKSWAGEN ORIGINAL BEARINGS ARE SKF BEARINGS.
COST FROM AGENTS R1100 EACH.
COST FROM SKF R190 EACH.
SPECS:
10 VKBA 1319
KIT 280 - WHEEL BEARING KIT
> Need to replace oxygen sensor in my 1991 mv 2.1
digifant syncro. Does
> not have to be genuine VW. Bosch or generic ok but need part no. as
> need to buy here in Australia. Could not find part no. in
> archives.Please advise.
> Thanks.
> Nick.
Nick,
The factory sensor is VW P/N 025 906 265B Bosch P/N 13931 - direct
plug in
replacement (and expensive!).
The alternate sensor is Bosch P/N 13913 - you will have to replace the plug
on this one, though. Make sure that your connections are waterproof
(solder
and use heat shrink tubing).
Don in Phoenix, AZ